PMC with 2 CAN bus channels

Tews PMC Module for Fieldbus Communication

The TPMC810 is a standard single-width 32 bit PMC with two independent CAN bus channels, isolated from system logic and from each other.

Two Philips SJA1000 CAN controllers (CAN specification 2.0B supported) are used.

CAN High Speed transceivers are used for the CAN bus I/O interface. An on board termination option (DIP switches) is provided for each CAN bus channel allowing to configure on board termination and pass through mode.

Each channel can generate an interrupt on INTA. Interrupts can be enabled and disabled separately.

The TPMC810 provides front panel I/O via two DB9 male connectors and rear panel I/O via P14.

Software support (TDRV010-SW-xx) for different operating systems is available.